The filling round table is designed for the filling of lump or separated material into containers of different sizes. The table is located next to the lamellar conveyor supplying empty containers for filling and removing filled containers. Containers are moved from the conveyor onto the table and back by transition pieces which vary according to the container diameters. The material for filling is supplied by a belt or modular conveyor. The supplied material is filled manually through holes in the plastic segments. These segments located along the perimeter of the table change according to the container size. It is possible to install two vibrating actuators for more compact filling of the material in the containers.
The table consists of two circular plates located above each other. The bottom carrier plate is situated on the level of the feeding conveyor lamellas. The containers supplied to the bottom plate are separated by the upper plate carrier segments. The height of this plate can be adjusted to the size of the filled container. The height is adjusted from a control panel using screw drives powered by an electric motor gearbox. The table rotating device is driven by a bevel gear with an electric motor located on the drive shaft. The table speed is controlled by a frequency changer, in combination with a variator.
The device is made of stainless steel structure (quality according to DIN 1.4301), including the connecting material of quality A2 and plastic components. All materials used have been certified for direct contact with food.
Type / technical parameters: PKS 1800 V9
Nominal diameter of the table
Dimensions of the desk frame
Adjustable height of the bottom table top, from the floor
900 – 1000 mm
Adjustable height between the bottom and filling plates